SAFETY TIPS-WALKING AND WORKING SURFACES

nelsonfan

General Requirements

1.The workplace must be maintained clean, orderly, sanitary, and as far as possible, in a dry condition.  Spills should be cleaned up promptly.

2.Areas that are constantly wet should have non-slip surfaces where personnel normally walk or work.

3.Every floor, working place, and passageway must be maintained free from protruding nails, splinters, holes, and loose boards.

4.Where mechanical handling equipment such as lift trucks is used, sufficient safe clearances must be provided for aisles at loading docks, through doorways, and wherever turns or passage must be made.  Aisles must not be obstructed.

5.All permanent aisles must be easily recognizable.  Usually aisles are identified by painting or taping lines on the floor.

6.The floor load capacity is the maximum weight that can be safely supported by the floor, expressed in pounds per square foot.  When this information is not available and when floor load capacity is in doubt, it is suggested that a competent engineer be consulted.  These floor load capacities must be posted in a readily visible location (except for slab floors with no basements).

大智

Thank you for sharing with us.

lipai7949

THANKS

daiweichun

Thank you for sharing with us.